I think I’m looking at original floorboards, rotting underlayment on top of those, a delightful assortment of other boards on top of that, then Pergo flooring.
I’m unsure of the best way to proceed. My gut says to pull up the top layer of boards to remove that underlayment, but then I worry that that turns into ripping up the whole floor.
(Left Side cabinet)
(Right side wall)
This is some minor water staining in an unseen area that’s been around for a long time. Ain’t nobody used that color green in 50 years.
_maybe _ there is a bit of.rotnon the bottom right wall but can’t tell from this.
Are you just planning on putting a dishwasher back in the hole ? What’s your goal? Because this is fine and honestly I wouldn’t do any of what you are thinking unless part of a much bigger project
Yep. Basically I was planning to ensure a level surface with more of that flooring in top so I can slide the dishwasher in. After running the new outlet to the breaker.
Run your hand under the boards on the right and push into the surface to check for any rot. It doesn’t look like rot but good to check since you are in here.
Then for the leveling… I’d get some furing strips and some shims and a panel of plywood get get a level set. Your going to need to redo the trim in the front regardless and you want the washer to fit well so you’ll need at least some furing strips and shims regardless.
Anything like a washer or a dishwasher that has pumps and shit that spins and a basin of water, you really want them level. But depending on the size of the washer and the hole, you might only be able to use shims.
How tight is the washer to the hole vertically?