Didn’t know where to post this. Just west and a bit north of Hays Ks is a windfarm. Today All of the wind powered generators were completely stopped. Had never seen that before. Anyone know why? There was plenty of wind.
Was it really windy? Turbines need steady medium wind speeds to operate; when the wind speed increases above a threshold they stop generating, and sometimes angle the blades to reduce the drag (so the mast and foundation aren’t overstressed).
It was really windy in a.m. As still pretty windy at 4 p.m. when I viewed them.
Wind turbines, not wind mills. Also: I’m going to take a guess here and assume that Hays Ks is in USA?
Yes
I can’t say for certain but some experience in the electric grid space gives me some of the following reasons:
The circuit they are connected to was faulted
They were transferred to a supply that they are not approved to generate on
If they are a large facility then they might have had a failed communication channel that is used to disconnect them if there’s an issue.
This isn’t an exhaustive list but just some common ones
The grid needs to be balanced, i.e. the supply and demand must match. You can’t pump more power than needed just because you can, otherwise everything stops working.
Given this, it’s possible the reason is that there wasn’t enough demand at that time, especially if other wind farms were generating enough power given the strong winds.
Not an expert by any means, just an educated guess.
Just guessing a bit further: I’m pretty sure there should be some battery capacity to compensate for temporary differences between supply and demand.
Saw that Man runs car into electric substation (AP) and wildfires ksn.com news happened the 19th. I haven’t yet found any news linking either of these to the shutdown.
Saving the birds? (/s)
Don’t forget the poor earthworms!!!
/S